OFM4X4 Hi-Lift Farm Jack 60″ (150 cm)
64,00 €
60″ (150 cm) steel farm jack. Lifts, winches, spreads and clamps – the most versatile recovery tool you can carry.
- Size: 60″ (150 cm)
- Weight: 13.4 kg
Never work under a vehicle supported only by a jack.
Only 1 left in stock
Hi-lift jack 60″ (150 cm)
A 150 cm cast and pressed-steel farm jack – the most versatile single tool in off-road recovery. Beyond lifting, it works as a hand winch, a spreader and a clamp, which is why it stays on the roof rack long after a bottle jack would have been left at home. The long beam gives the reach needed to lift a lifted vehicle on oversized tyres clear of a rut.
Technical specification
- Size: 60″ (150 cm)
- Construction: Cast and pressed steel
- Weight: 13.4 kg
What you can do with it
- Lift a wheel clear to pack rocks or a sand ladder underneath
- Use as a hand winch for short, controlled pulls
- Spread or clamp bodywork and chassis components in the field
- Change a wheel where a trolley jack has no flat ground to sit on
Safety – read before use
A farm jack is genuinely dangerous if used carelessly. The handle can kick back hard enough to break a jaw, so keep it under control and never stand in its arc. The jack is tall and unstable under load: never put any part of your body under a vehicle supported only by a hi-lift, always chock the wheels, and use axle stands before working underneath. Lift only from a solid, rated recovery point.
Care
Keep the climbing pins and the beam clean and lightly oiled. Grit in the mechanism is the usual cause of a jack that slips or jams under load.
| Weight | 13,4 kg |
|---|---|
| Dimensions | 150 cm |
| Brand | OFM4X4 |
| Product Type | Hi-Lift Jack |
| Load Rating | 2.5 t |
MAECENAS IACULIS
Vestibulum curae torquent diam diam commodo parturient penatibus nunc dui adipiscing convallis bulum parturient suspendisse parturient a.Parturient in parturient scelerisque nibh lectus quam a natoque adipiscing a vestibulum hendrerit et pharetra fames nunc natoque dui.
ADIPISCING CONVALLIS BULUM
- Vestibulum penatibus nunc dui adipiscing convallis bulum parturient suspendisse.
- Abitur parturient praesent lectus quam a natoque adipiscing a vestibulum hendre.
- Diam parturient dictumst parturient scelerisque nibh lectus.
Scelerisque adipiscing bibendum sem vestibulum et in a a a purus lectus faucibus lobortis tincidunt purus lectus nisl class eros.Condimentum a et ullamcorper dictumst mus et tristique elementum nam inceptos hac parturient scelerisque vestibulum amet elit ut volutpat.
Related products
Red Aluminium Hawse Fairlead 25cm – Synthetic Winch Rope
Anodised red aluminium hawse fairlead for winches running synthetic rope. The polished radius guides the rope onto the drum from any angle without the sharp edges or pinch points that shred synthetic line - which is exactly why roller fairleads must never be used with rope.
- Synthetic rope only - never fit synthetic rope to a roller fairlead
- Machined aluminium with a smooth radiused throat
- Red anodised finish
OFM4X4 Air Compressor 160L/min 12V – 150 PSI for 35″+ Tyres
A high-volume 12V compressor built for large off-road tyres. At 160 L/min it will re-inflate a set of 35-inch tyres in a realistic amount of time, where a small emergency pump would still be running an hour later.
- Airflow: 160 L/min
- Power supply: 12V DC, permanent magnet motor
- Current consumption: 40 A
- Maximum pressure: 150 PSI / 10 bar (120 PSI / 8 bar operating)
OFM4X4 Synthetic Winch Rope 10mm x 28m with Hook – Blue, 10,500 kg
10 mm x 28 m UHMWPE synthetic winch rope with hook, in blue. Six times lighter than steel cable, far safer if it fails, and easy to pull out to an anchor by hand.
- Size: 10 mm x 28 m
- Strength: 10,500 kg
- For winches: For Auto Off-Road winches with a capacity of 9,500–13,000 lbs
- Hook: Included
Use with a hawse fairlead only.
Reviews
There are no reviews yet.